Electronic Alarm; Replacing Remote Control Batteries - Ferrari California Owner's Manual

Replacing remote control batteries

If you press one of the three buttons of the key and this does not
activate the corresponding function, check for correct operation of
the alarm system functions using the other remote control before
replacing the batteries.
Replace the remote control batteries as follows:
- lever open the key cover C with a small screwdriver at the position
indicated by the arrow;
- remove the battery pushing in the direction indicated by the
D
arrow to release it from the retainer cover E;
- fit a new battery of the same type, observing the indicated polarity;
- close the key cover C.
Important note
Do not use sharp tools to remove the cover and be careful to
avoid damaging the remote control.
�

Electronic alarm

The electronic alarm system performs the following functions:
- remote control for central door locking/unlocking;
- perimeter surveillance, detecting if doors and lids are opened;
- motion surveillance, detecting intrusion into the passenger compartment;
- vehicle movement surveillance.
Activation
To activate the electronic alarm, press button
- the direction indicators flash once;
- the system "beeps"
- the red LED on the dashboard flashes
- the central door locking system is activated and the doors are locked.
The system activates after approximately 25 seconds.
When the electronic alarm is activated, the user may request
opening of the luggage compartment; in this case, the motion and
anti-lift sensors are temporarily deactivated.
� �
�
�
· General ·
F on the key:
1
• 17