Initiating Or Answering An Intercom Transmission; Adjusting The Volume - Motorola MC3000 Operating And Installation Manual

Operation

Initiating or Answering an Intercom Transmission

4. Release the Transmit button to allow you to listen for a response on the internal
speaker. The Transmit LED turns off when the button is released.
Method 4—Respond with the desk microphone or footswitch
1. Ensure the handset is on-hook (in the cradle).
2. Press and hold the Transmit button on the desk microphone or footswitch. The inter-
nal microphone is disconnected and the Transmit LED turns on while the button is
pushed.
3. Speak in the direction of the desk microphone.
4. Release the Transmit button to listen for a response on the internal speaker. The
Transmit LED turns off when the button is released.
Always allow a short delay after pressing the Transmit button, and before speaking, to
allow time for the radio channel to be established. For the best transmit audio quality,
maintain a speaking distance of 18 inches from the desk microphone.
Initiating or Answering an Intercom Transmission
You use the intercom to communicate between desksets without transmitting over the
radio channel/s.
To visually verify that you can initiate an intercom transmission, look at the Busy LED. If
the Busy LED is on, a parallel deskset is being used and you cannot transmit until the
Busy LED is off.
To transmit:
1. Press and hold the Intercom button. The Transmit LED turns on while the button is
pushed.
2. Speak in the direction of the internal microphone (located slightly to the right of center
on the bottom edge of the console). For the best transmit audio quality, maintain a
speaking distance of 18 inches from the internal microphone.
3. Release the Intercom button after you finish transmitting to allow you to hear the
receive audio from the internal speaker. The Transmit LED turns off when the button
is released.
To respond to an intercom call:
Press and hold the Intercom button only and speak into the internal microphone. If you
use the PTT press bar or the Transmit button, your response will be heard on the radio
channel as well as the intercom. You can only hear the receive audio if the Intercom but-
ton has been released.

Adjusting the Volume

There are three speakers that you can adjust the volume on:
3-20
MC3000 Digital Deskset Operator and Installation Manual
(6880309L15-A)