Busy Test; Audio Test - Motorola MC3000 Operating And Installation Manual

Installation
Configuring and Testing Deskset Functions
3. Plug the cable from the Digital Junction Box into the Deskset's 'Audio/Data' port. The
first line of the LCD display will show "Test Started" and the second line will show the
"<SW number of the Digital Junction Box>". Then the first line of the LCD display will
switch to the bar graph display and the second line will switch to showing the TX Line
and Busy Line signals.
A positive result of the test is when the first line of the LCD display shows a bar graph
building from left to right and the second line of the LCD display dynamically shows
the number of each incoming message (0 - 255).
If the link is established the deskset should be reading messages at least every 5 sec-
onds. If the link is not established, the deskset will only read its internal data message
signals every 10 seconds. If there is an internal problem with the deskset, there will be
no messages.
4. Press the Menu/Home button to exit the sub-menu. The first line of the LCD Display
will show "Data Test" and the second line will show "Press Menu".

4) Busy Test

To test the Busy Line link to the Digital Junction Box:
1. After you enter the program, press the Mode Up button three times to change the test
to the "Busy Test" which is the fourth test option. The first line of the LCD display will
show "Busy Test" and the second line of the LCD display will show "Press Menu".
2. Press the Menu/Home button to enter the sub-menu. The first line of the LCD display
will show "Test Started" and the second line of the LCD display will show "0 Busy".
Note: The Digital Junction Box sends a message at least every 5 seconds. When the
Digital Junction Box is not connected, the deskset will generate a Busy Line signal
every 10 seconds. In this case, the second line of the LCD display will show "001
Busy" after 10 seconds, and "002 Busy" after 20 seconds and so on.
3. Plug the cable from the Digital Junction Box into the Deskset's 'Audio/Data' port. The
first line of the LCD display will show "Test Started" and the second line will show the
"<SW number of the Digital Junction Box>". Then the first line of the LCD display will
switch to the bar graph display and the second line will switch to reading the Busy Line
signals.
A positive result of the test is when the first line of the LCD display shows a bar graph
building from left to right and the second line dynamically shows the number of each
busy signal (0 - 255).
If the link is established, the deskset should be reading messages at least every 5
seconds. If the link is not established, the deskset will only read its internal Busy Line
signals every 10 seconds. If there is an internal problem with the deskset, there will be
no messages.
4. Press the Menu/Home button to exit the sub-menu. The first line of the LCD Display
will show "Busy Test" and the second line will show "Press Menu".

5) Audio Test

To test the internal speaker and microphone, the handset mouthpiece and ear piece or
optionally an external headset or deskset microphone:
1. After you enter the program, press the Mode Up button four times to change the test
to the "Audio Test" which is the fifth test option. The first line of the LCD Display will
show "Test Audio". The second line of the LCD Display will show "Press Menu".
2-16
MC3000 Digital Deskset Operator and Installation Manual
(6880309L15-A)