Problems And Solutions - RCA RTD 152 Service Manual

Problems and Solutions

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your
dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the
guarantee.
Problems
No power
indication
No picture
No sound
Picture
distortion
Brightness
unstable or
noisy
The player
does not
work
No response
to key press
Remote
control does
not work
Note:
This produce incorporates copyright protection technology that is protected by method claims of certain of
certain U.S. patent and other intellectual Property rights owned by Macrovision Corporation and other rights
owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is
intended for home and other limited viewing users only, unless otherwise authorized by Macrovision
Corporation. Reverse engineering or disassembly is prohibited.
Cause
Power plug not connected
TV has not been set to the
correct video input
Video cable not
connected.
Audio cable not connected
tightly
Power of audio apparatus is
off
Audio output setting
incorrect
Disc is dirty
Fast forward/backward
activated
Affected by anti-piracy circuit
No disc
Disc not compatible
T he disc is placed upside
do wn
The disc not put in the tray
correctly
Disc is dirty
Player setting are incorrect
Parental lock is in effect
Interference of power wave or
other factors such as static
interference
The remote control
pointed at the remote sensor
on the front panel of the
player
The remote control is out of
specified range
Battery power exhausted
Plug the power cord into the power supply
Set correct TV video input format for receiving
firmly Firmly insert the video cable ends to the
Firmly insert the audio cable ends to the
Turn on the power of audio apparatus.
is Setup audio output correctly via the setup
is The picture may be distorted during fast
Connect the player directly to TV.
Load a compatible disc (Check the disc format
Load a compatible disc (Check the disc format
Change the setting via the setup menu.
Disable this function or reset the rating level.
Turn off the main switch or pull out the power
plug, plug it in and turn on the power again.
not Point the remote control at the remote sensor.
Make sure the remote control range within 7
- 34 -
Solution
the player's output signals.
related terminals.
related terminals.
menu.
Take out the disc and clean.
forward /backward playback.
Load a disc.
and its colour system).
and its colour system).
Check disc is put in correctly.
Clean the disc.
meters to the remote sensor.
Replace with new batteries.