Battery Operation - Wireless Solution S-1 Micro User Manual

Installation
The antenna is concealed within the unit, no external antenna is
required.
1 When not operating from internal battery power, the unit re-
quires a low voltage input: 12 to 24VDC supplied via the RJ45
socket.
2 If required, attach the supplied trussholder bracket to the rear of
the unit (see page 12).
DMX in,
(XLR male 5pin)
DMX in, DC power in (RJ45)
1: DMX- 5: +12-24VDC
2: DMX +
6: n/c
3: n/c 7: Signal GND
4: +12VDC 8: DC GND
Linking and unlinking
Please see page 4 for details.

Battery operation

When fully charged, the internal battery can support operation for
up to 2 hours. The
Level
indicator is ON. Use the button on the end panel to change
BATT
between battery operation (green indicator) and external power
(red indicator). When no external power is supplied, this switch can
be used to cease battery operation and power down the unit.
RADIO
ON: Indicates that of radio signal strength & battery charge
Level display is
showing signal
strength
BATT
ON: Indicates that
Level display is
showing battery
charge
LINK
ON: Normal operation
FLASH: Unlinking all receivers
RAPID FLASH: Linking with receivers
Battery button & indicators - Press to change
between battery (green indicator) and external
power input (red indicator) operation.
Fade button - Press to fade off/on the top
panel indicators. Note: When running from
the internal battery, the indicators fade off
automatically to conserve power.
indicators show battery charge when the
Level
Provides alternate indications
W-DMX
made in sweden
TX RX
Radio
Level
LINK CTRL
DATA POWER
Batt
DATA
ON: Transmitting DMX data
RX CTRL
&
FUNCTION
Press and release
to search for and
link with receivers
Wireless Solution
Sweden AB
FUNCTION
POWER
OFF: Switched off
or using battery
ON: External
power input
FLASH: Charging
Not used battery
BlackBox
S-1 Micro
Transmitter
Package Contents
In addition to this manual:
1 pc, BlackBox S-1 Micro
1 pc, RJ45 power cord
1 pc, Trussholder bracket
DMX Interface
Transceivers on bus: 32 (max)
Data rate: 250 kbps (max)
ESD protection*: ±15 kV
DC input
12-24VDC 1,5A (max)
Compliance declarations
ETSI: EN300 328 & 300 826
EMC: EN301 489-17
CE: EN60950
FCC: UQT-WDXOEMPCBF
IC: 6812A-WDMXOEM
ARIB: 06215559/AA/00
RF characteristics
Output power:
20 25** dBm
100 300** mW
Frequency range:
2402 to 2479 MHz
Channel bandwidth: 1
Sensitivity at 0.1% BER:
-95dBm
* Slewrate limited for
minimum of EMI in unter-
minated networks.
** Only in FCC output
power mode.