HobbyKing HK-7X User Manual
  1. Manuals
  2. Brands
  3. HobbyKing Manuals
  4. Remote Control
  5. HK-7X
  6. User manual
HobbyKing HK-7X User Manual

HobbyKing HK-7X User Manual

7 channel
Hide thumbs
Table of Contents

Advertisement

Quick Links

USER MANUAL

Advertisement

Table of Contents
loading

Related Manuals for HobbyKing HK-7X

Summary of Contents for HobbyKing HK-7X

  • Page 1 USER MANUAL...

  • Page 2: Liability Declaration

    ® HobbyKing.com products. ® The recommended or text technologies data in the technology introduction for HobbyKing.com only indicates ® the test result at that time, but it does not mean HobbyKing.com acknowledges the result in law.
  • Page 3 HK-7X 2.4GHz remote controller system at local, please operate only after other users pare the signal. HK-7X supports seven models saving in one transmitter, they are numbering as n1 to n7. The binding will save the serial number in receiver. So if you bind one receiver with n1, it can only work when the 2.Connect Devices to Receiver...

  • Page 4: Transmitter Panel

    Part2 Transmitter Manual 1 Features 1 LED display which shows model type and battery voltage on normal status. 2 7 models parameters store supported. 3 Support 5 points throttle(THR) curve in NORMAL mode and IDLE mode. 4 Support 5 points pitch(PIT) curve in NORMAL mode, IDLE mode and HOLD mode. 5 Support HELI(helicopter) mode and AERO mode.

  • Page 5: System Setting

    2 Transmitter Panel 4. Stic d usting Tighten the screw when finishing adusting. In HELI mode, it is used to switch NORMAL mode and IDLE mode. In AERO mode, it controls channel6. it is used to control dual rate of aileron, elevator and rudder.

  • Page 7: Dual Rate Setting

    .4 Dual Rate Setting . Gyro Sensitivity d usting The sensitivity value can be set from -100 +100. When it is greater than , the gyro is in head- lock mode, when the value is lesser than or equal to , the gyro is in non lock mode. The default value is G .7 T rottle Curve Setting at the same time...
  • Page 8 .7 T rottle Curve Setting Signal and Curve . Pitc Curve Setting . S as Mi ture Setting at the same time from the same time...

  • Page 9: Tail Mode

    u c annel setting There are six settings in V-tail mode. To enter setting, press UP and DN at the same time special When in HELI mode, the GEAR switch controls channel 7, and the AUX channel. There are two times, and five operations beyond are the same as in HELI mode.
  • Page 10 Delta ing Mode HK-7X can support seven models, each model can has its own parameters. To switch among the five models, you should hold UP and DN , then turn on transmitter, then press INC till "S1 xx" is shown like CHART20.
  • Page 11 HK-7X 7CH supports throttle warning. If the throttle stick not is in the lowest position when power on, the HK-7X 7CH is a digital device, it also has a signal output slot on the bottom. But in common using, the transmitter will block in warning status.

Table of Contents