Insert Editing - JVC GR-DVL155 Instructions Manual

Power Switch
Lock Button
Display
6 w
12 : 3 4
Remote sensor
REW
PAUSE
PLAY
RM-V700U
(optional)

Insert Editing

You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in and
outpoints. The original audio remains unchanged.
NOTES:
1
press PAUSE (6). Confirm the time code at this point
(
2
then press PAUSE (6).
3
control, then press PAUSE (6). "6w" and the Time
Code (min.:sec.) appear and the camcorder enters
Insert-Pause mode.
4
• Confirm the insert at the time code you checked in
• To pause editing, press START/STOP. Press it
5
STOP (5).
NOTES:
START/STOP
STOP
INSERT
Before performing the following steps, make sure that
"TIME CODE" is set to "ON" in the Menu Screen
( pg. 35, 37).
Insert Editing is not possible on a tape recorded in the
LP mode or on a blank portion of a tape.
To perform Insert Editing while watching in the
television, make connections (
Play back the tape, locate the Edit-Out point and
pg. 35, 37).
Press REW (2) until the Edit-In point is located,
Press and hold INSERT (w) on the remote
Press START/STOP to begin editing.
step 1.
again to resume editing.
To end Insert Editing, press START/STOP, then
Programme AE with special effects (
be used to spice up the scenes being edited during
Insert Editing.
During Insert Editing, the date and time information
changes.
If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert
Edting stops ( pg. 66).
49
EN
pg. 20).
pg. 24, 25) can