Table of Contents
Advertisement
Now gently tighten the strap against the holder. The strap should not slip any more
(fig.3). Repeat the operation for the second strap
Fit the holder to the desired position on the steering wheel. Pass the straps around the
wheel and slip the ends into the two free holes in the holder. Gently pull the straps so that
the holder no longer moves (fig.4).
You can now fit the remote control. Fit the remote control so that your thumbs can easily
reach the buttons (fig.5).
Fig. 3
5 - tURnInG on anD off
ATTENTION :
• If your Smart's battery is flat, the device needs one minute of charging before it
will start (cf. «Charging and autonomy»).
• Make sure the battery's protective film is removed from the remote control.
• During the initialisation sequence a screen message tells you if a new software
release is available for your device.
5.1 - first start-up:
To turn your smart on, press the on/off switch (7).
The first time you turn it on, a welcome screen is displayed while the smart application
system boots. You will be prompted for your language (cf. «Configuring your device»).
Once the language has been set, the smart continues its boot sequence (cf. «Normal
start-ups»).
5.2 - normal start-ups:
During normal start-ups, an audible welcome message
sounds and a welcome screen, asking you to press the
remote control, is displayed.
To activate the remote control, you must press any key for
15 seconds.
The main screen is displayed as soon as it detects the key.
à fig.3).
(fig.1
Fig. 4
Fig. 5
7
Advertisement
Table of Contents
