Table of Contents
Advertisement
4 - InstallatIon
4.1 - assembling the mount
The car mount is made up of two parts. A removable part allowing you to position your
smart as you wish, and a fixed part, with the self-adhesive suction cup, which holds the
mount firmly in place.
To assemble your mount, simply loosen the clamp screw slightly and snap the stanchion's
ball joint into the socket. Place the mount as desired on the clean windscreen or
dashboard, removing the suction cup's reusable protective film first. Position the mount as
desired, lowering the suction tab on the cup. Now slightly tighten the clamp screw in order
to position the mount with the device removal tab on top. Once this is done, tighten the
clamp screw further to lock firmly in position. To remove the mount, simply lift the suction
tab on the cup, then pull the suction cup tab. You can then easily remove the mount.
N.B. :
• With certain thermal resistant windscreens, position your device near the un-treated
area (generally near the rear-view mirror) to improve the GPS signal's reception.
• Do not over-tighten the clamp screw as you could damage or break the plastic parts.
• Make sure that the GPS antenna (9), situated on the back of the Smart, is facing
up and on the right side of the device.
4.2 - Installing the smart in the mount
Take your Smart in one hand and grip the mount with the other. Insert the bottom of your Smart
into the mount, and then apply slight upward pressure until the device clips into the mount.
To remove your Smart from the mount, hold the mount with one hand, then gently press the
device removal tab while pulling the Smart towards you. Alternatively, you can simply slide it to
one of the sides of the mount.
IMPORTANT :
For your own safety, avoid placing your Smart, or any related accessory, on an area
of the dashboard containing an airbag. If you are using the power cable to recharge,
position it such that it does not hinder your driving and does not obstruct access to
the vehicle's controls.
4.3 - assembling and mounting the remote control
Take one of the supplied straps and fold it back on itself at the third hole (fig.1).
Take the remote control holder in the other hand and pass the strap through the hole facing
you
(fig.2a)
being careful to position the fold towards the inside of the holder (fig.2b).
Fig. 1
www.inforad.eu
6
Fig. 2a
Fig. 2b
Advertisement
Table of Contents
