Battery; Battery Charge; Fuses; Bulb Replacement - PEUGEOT cc-250 Owner's Manual

B
ATTERY
Make sure you check that the battery is
disconnected before performing any
operations on it. Battery power leads must
never be disconnected while the engine is
running. Batteries contain harmful products. In case of
leakage, you are advised to consult a registered dealer
who is equipped to replace and dispose of batteries
without endangering nature and the environment.
B
ATTERY CHARGE
The battery must be charged in a well-ventilated area with
a suitable charger that can feed a tenth of the battery
capacity to avoid premature destruction. You are
therefore advised to go to a registered dealer to carry out
this operation.
Batteries contain sulphuric acid. Do not allow it to come
into contact with skin or eyes. While the battery is
charging, it can release explosive gases. Keep sources
of sparks, flames and incandescent products away from
it.
Battery fluid shall be topped up after full charge of the
battery and with demineralized water only.
Maintenance-free batteries.
A maintenance-free battery must never be opened for
topping up.
Battery requiring maintenance.
Check and top up the level between the "UPPER"
(maximum) and "LOWER" (minimum) marks.
The electrical system is protected by fuses placed near
the battery. (1) (fuses from F1 to F6).
1
The accessory socket is protected by fuse F7 placed on
the right side of the glove box (2).
Please refer to detailed fuse allocation on page 12.
If a fuse often blows this is usually a sign of a short circuit
in the electrical circuit. You are advised to have the
system checked by a registered dealer.
You are advised to switch off the ignition
before changing a fuse and always to
replace it with a fuse of the same rating. If
you do not do so, this may lead to damage
in the electrical circuit or even a fire.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
F
USES
Headlight bulb.
Indicator bulbs.
2
Rear light and indicator bulbs.
B
ULB REPLACEMENT
The front panel must be removed before a headlight bulb
can be replaced.
The front panel must be removed before an indicator bulb
can be replaced.
The rear fairing must be removed before a rear light bulb
can be changed.
You are advised to contact a registered dealer to have this
operation carried out.
FR
GB
DE
IT
ES
NL
GR
SE
PT
FI
DK
11/14