Connecting To The Organ; When Connecting Only The Mx-200 - Rodgers MX-200 Owner's Manual

Setting up your MX-200

Connecting to the Organ

The MX-200 contains no amplifier or speakers. Refer to the
diagram below and connect it to the organ.
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before making any connections.

■ When Connecting Only the MX-200

fig.Connect1.e
Rodgers organ
AC Adaptor
(ACI series
or
PSB-1U)
If you need to use the MX-200 monaurally, connect only to
the L (MONO) OUTPUT phone jack.
The MX-200's headphone output allows you to hear only the
sounds made by the MX-200 itself. Use the organ's
headphone output if you want to hear the MX-200's sounds
combined with the organ sound through headphones.
18
Sequencer OUT
When connecting to an organ
that is not equipped with a
Sequencer connector, connect
to the MIDI OUT connector.
←
If the organ is equipped with a
DC OUT jack, you can use the
DC cable included with the organ
to supply power to the MX-200.
MX-200
This headphone jack only allows you to
listen to the tones from the MIDI couplers.
To enjoy the sounds from the entire organ,
use the organ's headphone jack.
1.
Make sure that the power to all connected devices
is turned off before making any connections.
2.
Connect audio cables and MIDI cables as shown
in the figure.
3.
Connect the included AC adaptor to the DC IN
jack, and plug into a power outlet.
MIDI OUT
MIDI IN
When Powering the MX-200 from the
Organ
Certain Rodgers organs come equipped with a DC OUT jack
for use with external devices. You can use this to supply
power to the MX-200. The organ is equipped with a
dedicated power cord; use this to connect the MX-200. This
feature allows you to turn on the power to the MX-200 and
the organ simultaneously.
Leave the MX-200's POWER switch on at all times.
Headphones