Backspace Cursor/Delete Character - Radio Shack PC-2 TRS-80 Owner's Manual

If the current line is in the middle of a program, pressing
CD
will display the next lower numbered program line.
Holding
CD
down will activate a repeat function and the Computer will scroll "up" through the program until
the first program line is reached.
When you press
(SHIFT)
GJ
,the Computer will display
"y".
CD
can be used much the same as [ [ ) except that you cannot single-step through a program by pressing
CD .
Pressing and holding down
(]J
in the RUN Mode after BREAK has been pressed will display the program line
which was executed just before the "break" occurred.
Another difference is that (in the RUN Mode), pressing
CD
after an error message has been displayed will display
the program line with the Cursor positioned on the cause of the error. The offending line will be displayed only
as long as you hold down
CD.
Release
CD
and the error message will disappear, press
CD
and the line will
appear. To correct the line, press
@,
go to PROgram Mode, then press
CD
or (]J and begin editing.
8 )
Backspace Cursor/Delete Character
Any time you are writing or editing a program line, you can move the Cursor to the left by pressing
8 ) .
Doing
so wi II not erase any existing character.
When the Cursor is in the "current" position while typing characters which appear on the Display, it appears as
36