Figure 5-4: The Adapter's Leds; Figure 5-5: Digital Signature Not Found Screen; Figure 5-6: Positioning The Adapter's Antenna - Linksys WUSB11 User Manual

Wireless-B USB Notebook Adapter
2. The Power LED should light up when the Adapter is plugged in. (Make sure your PC is powered on.)
3. If you are using Windows 2000, you may see a Windows Digital Signature warning. As the Adapter has been
tested and found to work with Windows, you may click the Yes button to continue.
4. Raise the antenna. Make sure the antenna is positioned straight up into the air, at a 90º angle from the
Adapter. This will ensure optimum wireless operating range and performance.
NOTE: If you want to attach the Adapter onto your wall, go to the next section, "Using the Adapter's
Wall Mount," before proceeding to the appropriate chapter for your PC's operating system.
If your PC is running Windows XP, proceed to "Chapter 6: Driver Installation and Configuration for
Windows XP."
If your PC is running Windows 98SE, Me, or 2000, the installation of the Wireless-B USB Network
Adapter is complete. If you want to check the link information, search for available wireless networks,
or make additional configuration changes, proceed to "Chapter 7: Using the Wireless Network Monitor
Chapter 5: Hardware Installation
Connecting the Adapter
for Windows 98SE, Me, and 2000."

Figure 5-4: The Adapter's LEDs

Figure 5-5: Digital Signature Not Found Screen

Figure 5-6: Positioning the Adapter's Antenna

12