Getting Started; The Remote Control - JVC I'Art 0406TNH-II-IM User Manual

Quick Setup

Getting Started

These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away. If you have questions, or for more detailed
information on any of these steps, please consult other sections of this manual.
Step 1 – The Remote Control
Before you can operate your remote control, you first need to
install the batteries (included).
Raise the latch on the remote's back cover to remove. Insert
two batteries, carefully noting the "+" and "–" markings, and
place the "–" end in the remote first. Snap the cover back into
place.
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The top
and bottom buttons will scan forward and back through the
available channels. To move rapidly through the channels
using JVC's Hyperscan feature, press and hold CH+
or CH –. The channels will zip by at a rate of about four
channels per second. The right and left buttons will turn
the volume up or down. These buttons are also marked
with four arrows and are used with JVC's onscreen menu
system. To use the onscreen menus, press the M
button.
Basic Operation
Turn the television on and off by pressing the P
corner of the remote. If this is the first time you are turning on the TV, the
interactive plug-in menu appears.
10
ENU
button at the top right
OWER