Table of Contents
Advertisement
19" and 23" Radiance and 24" EndoVue Display:
Each step bracket is stamped with a part number (P/N). For
displays, select step bracket P/N 20C0660. Replace the left hand mounting screws with 2 of the provided
mounting screws. Do not tighten them. Remove the two right hand screws from the VESA mount . With
the side stamped FRONT facing the front of the display, slide the step bracket between the VESA mount
and the back of the display until notches labeled for the display you are working with fit over the two left
hand screws. Replace the right hand screws with the screws provided and tighten all screws. With the
black surface of a ZeroWire Rx or Tx module facing the front of the display, align the slot on the bottom of
the module with the top of the bracket and push the module down on the bracket until the module seats.
This side faces the
front of the display.
"L" Bracket for 24" and 26" Radiance Displays:
The "L" bracket P/N 20C0830, like the Extended Height Bracket (P/N 20C0669), raises the installed height of
the ZeroWire unit by 2.4" (61mm) to improve the ZeroWire transmitter's coverage and the ZeroWire
receiver's reception. The "L" bracket also offsets the ZeroWire unit to the left (Figure 1) of the display's
center for improved boom arm clearance. If desired the "L" bracket may be reversed to offset the ZeroWire
unit to the right (Figure 2) of the display's center. Installation of the "L" bracket is the same as described on
the previous page for the standard height bracket.
Figure 1
Radiance 19"
and
23"
Figure 2
and
EndoVue 24"
4
Advertisement
Table of Contents
