Table of Contents
Advertisement
Installation
The only mounting bracket included with the Zerowire is the
sold separately.
Desktop:
With the side stamped FRONT and the black surface of a ZeroWire Rx or Tx module facing you, insert the
desktop mount into the slot in the bottom of the module and push downwards on the mount until the
module seats.
Install with this side facing the
black side of the Rx or Tx.
Optional Mounting Brackets:
Extended Height Bracket for 24" and 26" Radiance Displays:
Each step bracket is stamped with a part number (P/N). For
extended height step bracket P/N 20C0669 . Replace the left hand mounting screws with 2 of the provided
mounting screws. Do not tighten them. Remove the two right hand screws from the VESA mount . With
the side stamped FRONT facing the front of the display, slide the step bracket between the VESA mount
and the back of the display until notches labeled for the display you are working with fit over the two left
hand screws. Replace the right hand screws with the screws provided and tighten all screws. With the
black surface of a ZeroWire Rx or Tx module facing the front of the display, align the slot on the bottom of
the module with the top of the bracket and push the module down on the bracket until the module seats.
Figure 1 shows the completed assembly.
This side faces the
front of the display.
3
Desktop
mount. All other brackets are
Radiance 24"
and
26"
Figure 1
displays, select the
Advertisement
Table of Contents
