Key Start Switch; Glow Signal; Glow Plug; Tractor Meter - Mitsubishi MT160 Instruction Book

•
KEY SART SWITCH (Engine on-off key switch)
Heat position . . . . . . . . . Power applied to the glow plug
OFF position . . . . . . . . . Engine and all lights turned off
ON position . . . . . . . . . . Engine running and electrical
circuit energized.
START position . . . . . . . Starts the engine then key
returns to "ON" position.
ACAUTION
Be sure to remove key whenever tractor is not in
operation.
GLOW SIGNAL
When the starter key is turned to "HEAT" position, inter-
nal coil glows in red indicating that the engine is preheated.
The engine will be preheated in 5 sec. under normal tem-
perature.
GLOW PLUG
The engine is fitted with speed heating sheathed glow plug
which preheat the combustion chamber so that the engine
may be started easily even in cold weather.
-9-
TRACTOR METER
The tractor meter indicates engine rpm.
Indication of Meter
P.T.O. shift rotation
2,340 at P.T.O. 1st shift 540 rpm
1,793 at P.T.O. 3rd shift 1,000 rpm
BATTERY CHARGE WARNING LAMP
[In the monitoring lamp unit (L.H.)]
When the starter switch is set to "ON", this lamp lights up.
When the battery is being charged normally wh i Ie the
engine is running the lamp should go off. If the lamp
continues to light, stop the engine immediately and see
your Mitsubishi dealer.
OIL PRESSURE WARNING LAMP
[In the monitoring lamp unit (L.H.)]
When the starter key is switched "ON", this lamp lights up.
When oil is circulating normally while the engine is running,
the lamp turns off. If the lamp still lights up after the
engine has been started, stop the engine immediately and
check the engine lubrication oil level. If that is OK, see
your Mitsubishi dealer.