Table of Contents
Advertisement
Serial Port B Mode
The field allows you to specify the operation mode for serial port "COM
B". Settings are:
Normal:
RS-232C Serial Port
IrDA:
IrDA-compliant Serial Infrared Port
ASKIR:
Amplitude Shift Keyed Infrared Port
RxD, TxD Active
This setting controls the receiving and transmitting speed of the IR pe-
ripheral in use. Setting options: Hi/Hi, Hi/Lo, Lo/Hi, Lo/Lo.
IR Transmission Delay
This setting determines whether the IR transmission rate will be delayed
while converting to receiving mode. Setting options: Disabled, Enabled.
IR Duplex Mode
This setting controls the operating mode of IR transmission/reception.
Setting options: Full, Half. Under Full Duplex mode, synchronous, bi-
directional transmission/reception is allowed. Under Half Duplex mode,
only asynchronous, bi-directional transmission/reception is allowed.
IR Pin Select
Please consult your IR peripheral documentation to select the correct set-
ting of the TxD and RxD signals. Setting options: RxD2/TxD2, IR-Rx2Tx2.
Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port. Settings:
378/IRQ7, 278/IRQ5, 3BC/IRQ7 and Disabled.
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
ECP + EPP: Extended Capability Port + Enhanced Parallel Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose
"SPP." To operate the onboard parallel port in the EPP mode simultaneously,
choose "EPP." By choosing "ECP", the onboard parallel port will operate
in ECP mode only. Choosing "ECP + EPP" will allow the onboard parallel
port to support both the ECP and EPP modes simultaneously.
AWARD
3-17
BIOS Setup
®
Hide quick links:
Advertisement
Table of Contents
