Lcd Display - Saitek SmartCharger Instruction Manual

energy left will be indicated by the number of bars illuminated on the
Energy symbol display. The greater the number of energy bars
suitable for recharging, the Bad Battery symbol (Jg> will appear. Do not
attempt to recharge the battery in this case.
Note: It is recommended that you test only one battery at a time in
order to gain an accurate representation of each individual battery's
voltage and level of energy left as displayed by the Energy bars.
6. LID BUTTON Press to release the lid so that you can then open it.
The charging process is conducted only when the lid is firmly closed.

7. LCD DISPLAY

a. Soft-Start symbol: The Soft-Start symbol will light up and the
inner segment of the symbol will flash during Soft-Start mode.
The bars of the Energy symbol will light up in a sequence that
converges in the middle.
b. Fast Charge symbol: The Fast Charge symbol will light up and
the inner FAST icon of the symbol will flash during Fast Charge
mode. The bars of the Energy symbol will light up in a sequence
that cycles from bottom to top.
c.
the Top-Off/Trickle Charge symbol Q will light up and the
Top-Off / Trickle Charge icons v. ^4 °f
The bottom four energy bars of the Energy symbol will also light
up, while the top bar will flash. When the 1.2V Ni-Cd/Ni-MH
battery is fully recharged, the SmartCharger will enter Trickle
Charge mode. During this time, all of the energy bars will light
up, the Charged Battery symbol ^ will appear and the Top-Off/
Trickle Charge icons of the symbol will flash. The unit will stay in
Trickle Charge mode until you open the lid.
d. Intelligent Discharge System (IDS) symbol: The IDS symbol
will light up and the upper triangle of the symbol will flash
during discharging. The bars of the Energy symbol will light up in
a sequence that cycles from top to bottom.
e. Battery Analyzer symbol: Cycles when a 1.2V Ni-Cd/Ni-MH
battery is being analyzed. The outline of the Energy symbol will
also light up during this time.
f. Voltage indicator: Shows the battery's voltage during Battery
Analyzer mode. It is recommended that you test only one battery
at a time in order to gain an accurate representation of each
individual battery's voltage and level of energy left as
indicated by the number of energy bars.
g. Loading symbol: Flashes to remind you to insert the batteries.
h. Bad Battery symbol: Appears if the 1.2V Ni-Cd/Ni-MH battery
is bad and cannot be recharged.
i. Charged Battery symbol: This is the same symbol as the Bad
Battery symbol, but without a circle around the flash. The
Charged Battery symbol appears when the SmartCharger has
symbol will flash.