Using In Upright Steam Cleaning Mode - Morphy Richards Upright and Handheld Steam Cleaner Instructions Manual

VC720502MUK Rev2_Instruction Book 07/06/2013 15:41 Page 6

Using in upright steam cleaning mode

IMPORTANT: Before use, hardfloors should be thoroughly swept and carpets should be thoroughly dry vacuumed.
However, we recommend that the steam cleaner is not used on:
• bare wooden floors or any surfaces where wood is exposed (as it will absorb moisture and may distort).
• damaged hardfloors or hardfloors with gaps present (as it will absorb moisture and may distort).
Also, do not keep the steam cleaner in one place for an extended period, because the continual heat may cause
damage to carpets and some hardfloor types such as laminate flooring.
On wood and laminate flooring, do not make the floor overly wet - ALWAYS set the steam to minimum.
Please disconnect and allow the unit to cool on the cooling rest tray
attachments.
Press the water tank release button
of the water tank (17)
handheld steam cleaner (9).
Remove the filler cap
anti-clockwise to the 'unlock' position, then lift it out.
Before filling, read the Anti-scale chapter on page 10.
Fill the water tank.
Replace the filler cap and turn it clockwise to the
'lock' position.
Replace the water tank.
NOTE: Insert the water tank, base first, then click the
top into place.
Rotate the upper cord storage hook
release the power cord (11).
Secure the power cord in the cord holder (3).
6
1
(13) on the top
to remove it from the
(15) by rotating it
3
(4) to quickly
(26) before changing cloths and
Attach the micro-fibre floor cloth
floorhead (22), securing it in place by tightening
the toggle (25).
NOTE: The cloth you choose and the floor type
to be cleaned may affect how easy it is to push
the steam cleaner across your floor surface.
WARNING: Before switching ON, ensure the
floorhead is located safely away from persons
or animals.
Plug in at the mains outlet and switch on the
steam cleaner at the On/Off power switch (16).
The power indicator light (19)
steam will be ready to be emitted after around 30
seconds (when the steam trigger
2
(24) to the
4
will illuminate and
(2) is pressed).