Initial Settings - JVC Natural Vision AV-24WT2EK Instructions Manual

4. Turning the power and TV on
1.
Press the Main power button on the TV to turn
the power on.
The Power lamp lights red (power on), then green (TV
on).
If the power lamp stays red and does not change to green:
Your TV is in the standby mode. Press the Standby button on the
remote control to turn your TV on.

5. Initial Settings

• When the TV is first turned ON, it enters into the initial setting mode, and
the JVC logo is displayed.
1.
Press any button on the remote control.
LANGUAGE menu appears.
Selecting the on-screen language
You can select your language from ten languages listed on the LANGUAGE
menu. The displayed menus on the screen are described in the selected
language.
2.
Press
/
ENGLISH.
3.
Press OK button.
English is set for the on-screen display
description, and the AUTO PROGRAM menu
appears.
Automatically allocating stations to PR channels
To view a TV programme, you must first allocate broadcast stations to PR
channels. You can automatically allocate up to 99 stations to PR channels
PR1 to PR 99 on this TV. Broadcast stations that can be received are
automatically determined and set to PR channels.
8
button to select
LANGUAGE
ENGLISH
FRAN¸ C AIS
DEUTSCH
ITALIANO
CASTELLANO
NEDERLANDS
DANSK
NORSK
SVENSKA
SUOMI
:EXIT :OK
TV OK
AUTO PROGRAM
START
CANCEL
:EXIT :OK
TV OK
Note:
• You can also press the PR channel
/ button, a number button or the
up/down button on the front panel to
turn the TV on.
Note:
• The TV enters into the initial setting
mode only once when the TV is first
turned ON. If you turn the TV off or exit
from the setting menu while performing
the initial settings by mistake, you must
redo the initial settings, "LANGUAGE"
and "AUTO PROGRAM", following the
procedures described in page 20.