Remote Control - Sharp LC-32LB261U User Manual

Problem Solution
Good picture, but
• Increase the volume.
no sound.
• Make sure that the sound is not
• Make sure that you do not have
• Make sure that the correct
• Make sure that the audio cables
• Make sure that the antenna or
• If you are using an antenna, the
• The audio cable(s) you are using
Poor picture.
• Make sure that the room is not
• If an S-VHS camera or a
A retail banner is To turn off the retail banner:
displayed.
Press MENU, press
1
highlight Settings, then press
ENTER.
Press
2
All, then press ENTER.
Press
3
Banner, then press ENTER.
Press
4
then press ENTER.
Press EXIT to close the menu.
5
Good sound, but
• Adjust the contrast, color, and
poor color.
muted.
headphones connected. When
headphones are connected, no
sound comes from the TV
speakers.
audio mode is selected.
are connected correctly and
securely to your TV.
cable TV is connected correctly
and securely. See "Connecting a
cable or satellite box" on
page 13 or "Connecting an
antenna or cable TV (no box)"
on page 18.
digital channel signal may be
low. To check the digital
channel signal strength, see
"Checking the digital signal
strength" on page 57.
may be bad. Try a new set.
too bright. Light reflecting off
the screen can make the picture
difficult to see.
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
or to
or to highlight Reset
or to highlight Retail
or to highight Off,
brightness settings. See
"Adjusting the TV picture" on
page 49.
Problem Solution
Audio noise.
• Other devices (for example, a
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote
• Make sure that the power cord is
control does
correctly connected to your TV
not work.
and a power outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly
at the remote control sensor on
your TV. For the location of the
remote control sensor, see "Front"
on page 8.
• The supplied batteries are
wrapped tightly in clear plastic.
Make sure that you have removed
this plastic from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control
page 36.
• Replace dead batteries with new
batteries. See
control
LC-32LB261U Sharp 32" LED TV
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
"Adjusting sound settings" on
page 52.
are connected correctly and
securely to your TV.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
"Installing
batteries" on
"Installing remote
batteries" on page 36.
71