Understanding The Basics; Turning Your Tv On Or Off; Selecting The Video Input Source - Sharp LC-32LB261U User Manual

C If you select Satellite Box, a message asks
how you connected the satellite box to your
TV:
• Select HDMI, Component, or AV, then press
ENTER if you connected a satellite box to
your TV using one of these cables. Read the
message, then press ENTER to close the
wizard.
• Select Coaxial, then press ENTER if you
connected a satellite box to your TV using a
coaxial cable. Read the message, then press
ENTER to start the channel scan (VHF
channels only).
Note
You can press EXIT to stop the auto channel
search, but you will need to run the auto
channel search again to create a channel
list.
14 To watch TV, press INPUT, press
highlight the video input source for your TV in the
INPUT SOURCE list, then press ENTER.
• If your TV is connected to an antenna, cable TV
(no box), or cable or satellite TV box using a
coaxial cable, select TV.
• If your TV is connected to a cable or satellite box
using an HDMI cable or HDMI cable with a DVI
adapter, select HDMI 1 or HDMI 2.
• If your TV is connected to a cable or satellite box
using a component video cable, select
Component.
• If your TV is connected to a cable or satellite box
using a composite video cable, select AV.
Understanding the
basics

Turning your TV on or off

Selecting the video input source

or to
LC-32LB261U Sharp 32" LED TV
1 Make sure that the power cord is connected to a
power outlet. See "Connecting
page 35.
2 Press POWER to turn on your TV. The power
indicator turns blue.
3 Press POWER again to turn off your TV. Your TV
enters standby mode, and the power indicator
turns red.
Warning
When your TV is in standby mode, it is still
receiving power. To completely disconnect
power, unplug the power cord.
Note
If your TV does not receive an input signal
for several minutes, it automatically goes
into standby mode.
1 Turn on your TV, then press INPUT. The INPUT
SOURCE list opens.
2 Press or to select a video input source, then
press ENTER.
Note
The INPUT SOURCE list displays
Component when a component video
device is connected and turned on or
displays AV when a composite video
device is connected and turned on.
power" on
39