Advertisement
Available languages
Available languages
Caring for Your Washer/Dryer
In This Section
Page
Page
Maintenance-every
load . . . . . . . . . . . . . . . . . . . . 16
Tips for caring for your washer/dryer . . 19
Maintenance-as needed . . . . . . . . . . . . . . . . . . . . . 16
Care during periods of non-use . . . . . . . . ,.. 19
Washers and dryers require regular maintenance.
Follow the suggestions
below to maintain
your washer/dryer
properly.
Maintenance-every
load
Cleaning
the washer
lint filter
Clean the filter at the bottom of the agitator
after every load for the best filtering results.
To clean:
1.
Lift off the agitator barrel.
2. Wash or wipe the filter clean in the bottom
of the agitator barrel. The filter is not
removable.
3. Replace agitator barrel. Snap it into
place.
Cleaning
the dryer
lint screen
The lint screen is located inside the dryer
drum, on the back wall.
Clean it before each
load. A screen blocked by lint can increase
drying time.
1.
Open the door and pull the lint screen
straight out.
2. Squeeze the body of the lint screen lightly
while pulling the cover off. (See illustra-
tion.)
3. Roll lint off the screen with your fingers. Do
not rinse or wash the screen to remove lint.
Wet lint is hard to remove.
4. Replace cover on lint screen body. Push
the lint screen firmly back into place and
close the door.
Manual c
lint filter
Do not run the dryer with the lint screen
loose, damaged, blocked, or missing.
Doing so can cause overheating and
damage to both the dryer and fabrics.
Maintenance-as
needed
Use the following suggestions
about cleaning and
lint removal to maintain your washer/
dryer and keep it operating efficiently.
16
Advertisement
