Ethernet Connection - Emotiva XMC-1 User Manual

Rear panel - Ethernet and UsB Update ports
FM AM
7.1 ANALOG IN CENTER ANALOG IN
FRONT SURR BACK SUB 3
ANALOG IN 1
RB
PUSH PUSH
BALANCED ANALOG IN

1. Ethernet Connection

The XMC-1's Ethernet connection is used to connect the XMC-1 to the Internet via your home
network. A network connection is required in order to configure Dirac Live automatic room
correction, and to allow Ethernet-based or Internet-based remote control apps to connect to the
XMC-1 .
Note: A network connection with an Internet connection is required for configuring Dirac live
but, once DIrac is configured, the XMC-1 does NoT need to remain connected to the Internet - or
to your local network - to operate.
Note: The XMC-1 currently does NoT have the ability to play audio or video sources via the
Ethernet input.
2. Rear Panel USB Input
This input is used to apply firmware updates to the XMC-1 via a standard USB stick (thumb drive).
XMC-1: User Manual
8 7
RECORD ZONE OUT
OUT
2 IN OUT Z1 Z2
RS R C
7 CHANNEL ANALOG OUT
6 5 4 3
3 2 1
DIGITAL AUDIO AES/EBU
L LS LB
Page 69
1
2
2 1
IR IN
IR OUT
R L
SUBWOOFER OUT
OUT
1 2
TRIGGER OUT
1 3
2 4