Remington MB4040AU Use & Care Manual

your hair growth or trim against your hair growth, whichever
HOW TO USE YOUR TRIMMER
is preferred.
Here are a few tips for trimming facial hair (guide only).
NOTE: Since all hairs do not grow in the same direction, you may
Tips for best results
want to try different trimming methods (i.e. upwards, downwards
• Beard, moustache and sideburn hairs should be dry.
or across). Practice is best for optimum results.
• After achieving the desired length, use a downward motion
• Avoid using lotions before using your trimmer. Comb your hair
in the direction that it grows. to blend moustache hairs.
• When finished trimming, turn the power to OFF.
• Remove trimmer comb attachments if you are: defining
hairline edges such as sideburns, trimming the nape of your NOTE: Use slow light pressure. Too much pressure may trim off
neck, trimming your beard line on front of neck.
more hair than desired.
To Trim Sideburns
Trimming Beards
• Comb sideburns following the direction of your hair growth.
• Before you begin, comb your hair in the direction that it grows
so that the hairs are at their maximum height and facing in the
• Hold the trimmer vertically with either of the trimmer blades
same direction. facing you.
• Determine how much hair you wish to trim. Remember, until
• Trim sideburns using a downward motion.
you are familiar with using the trimmer, it is better to select a
• When finished trimming, turn the power to OFF.
longer hair length setting in order not to trim too much hair.
• Turn the trimmer's power switch ON and begin trimming. Trimming the Nape of Your Neck
NOTE: You will need a hand mirror for this operation if performing
• Start trimming under your chin, and following your jawbone
it alone.
line. Trim hairs using a downward motion following the
• Before you begin, remove the attachable combs.
direction of your hair growth or trim against your hair growth,
whichever is preferred. Work toward your ear and upper beard • Use your fingers to lift the hair at the base of your head up off
line using an upward motion. Allow the hair length attachment
the neck. Your index finger should be covering the roots of the
to follow the contour of your face. hairs you are lifting to prevent accidental removal by the trimmer.
• When finished trimming, turn the power to OFF. • Using your other hand, hold the trimmer to the base of your
neck with the cutting unit facing up, and move the personal
To Define the Beard Line
trimmer up the length of the neck until it touches your finger
• Start with the edge of the beard line and with the cutting
covering the hair roots at the base of your head.
blades resting lightly against your skin. Use downward
• Be sure to move the unit slowly when performing this
motions towards the edge of the beard line to trim the
operation and to keep the hair roots at the base of your head
beard line to the desired shape in the facial areas and
out of the way of the trimmer.
around the neck.
CLEANING AND MAINTAINING YOUR TRIMMER
To Trim the Edges of a Moustache
• Always clean the trimming system attachments regularly
• Moustache hairs should be dry.
to ensure maximum performance and a proper operating life.
• Use a small comb to comb the hairs straight for trimming.
• Unplug adaptor from wall outlet and ensure your trimmer
Hold the trimmer with the Goatee trimmer blade facing you.
is turned off
• Trim hairs using a downward motion following the direction of
• Remove the adjustable combs before cleaning.
8
DO NOT CLEAN YOUR TRIMMER OR ATTACHMENTS
WITH WATER
NOTE: Your Trimmer attachments are permanently lubricated,
so must be cleaned with the brush provided.
NOTE: Blades must be lubricated again with oil if rinsed under
water. Add 1 to 2 drops of sewing machine oil to the blade.
CLEANING ATTACHMENTS WITH THE CLEANING BRUSH
• After removing attachment, thoroughly brush and blowout
hair clippings from cutting system, attachment, and top
of trimmer handle.
This product is not suitable to use in a bath or shower.
The trimmer conforms to radio frequency
interference requirements.
Any product purchased and used commercially
carries a limited 90 Day Warranty.
9 10
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited 8. In order to claim under the warranty granted under clause 3 you must:
WARRANTY AGAINST DEFECTS (a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid
In this warranty: freight within the Warranty Period accompanied with (i) the legible and unmodified
original proof of purchase, which clearly indicates the name and address of the
Australian Consumer Law means the Australian consumer law set out in Schedule 2
Supplier, the date and place of purchase, the product name or other product serial
to the Competition and Consumer Act 2010;
number and (ii) this warranty.
CGA means the New Zealand Consumer Guarantees Act 1993;
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
Goods means the product or equipment which was accompanied by this warranty and
(b) The Goods have been serviced or otherwise repaired by a person not authorised to
purchased in Australia or New Zealand, as the case may be;
do so by us or where non approved replaced parts are used.
Manufacturer, We or us means:
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
industrial or commercial use of the Goods. The Goods must be connected to the electrical
ACN, 007 070 573; or voltage requirements as specified in the ratings label located on the Goods.
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited, 11. This warranty does not cover the cost of claiming under the warranty or transport of the
as the case may be, contact details as set out at the end of this warranty; Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
in Australia or in New Zealand; and
Contact us or the Supplier for further details.
You means you, the original end-user purchaser of the Goods.
Spectrum Brands Australia Pty Ltd
1. Our goods come with guarantees that cannot be excluded under the Australian
Chifley Business Park
Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure
1 Chifley Drive
and compensation for any other reasonably foreseeable loss or damage. You are also
Mentone, VIC 3194 Australia
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
Customer service in Australia: 1800 623 118
quality and the failure does not amount to a major failure.
E-mail: consumer.enquiry@remington-products.com.au
2. The benefits provided by this Warranty are in addition to all other rights and remedies in
Website: www.remington-products.com.au
respect of the Goods which the consumer has under either the Australian Consumer Law
or the CGA. The original purchaser of the Goods is provided with the following Warranty Spectrum Brands New Zealand Limited
subject to the Warranty Conditions: Building C, Ground Floor
3. We warrant the Goods for all parts defective in workmanship or materials for the period 600 Great South Road,
of two (2) years from the date of purchase (Warranty Period). If the Goods prove Greenlane, Auckland 1051 New Zealand
defective within the Warranty Period by reason of improper workmanship or material, Customer service in New Zealand: 0800 736 776
we may, at our own discretion, repair or replace the Goods without charge. E-mail: info@remington.co.nz
Website: www.remington-products.com.au
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer's instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable to
misuse, abuse, accident or non-observance of manufacturer's instructions on the part of
the user. As far as the law permits, the manufacturer does not accept liability for any
REMINGTON SERVICE HOTLINE
direct or consequential loss, damage or other expense caused by or arising out of any
 Australia 1800 623 118 (toll free)
failure to use the Goods in accordance with the manufacturer's instructions.

New Zealand 0800 736 776 (toll free)
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods
are included under this Warranty only where there is a defect in workmanship or
AUTHORISED REPAIR CENTRES
materials used.
Visit www.remington-products.com.au for Authorised repair centre details.
6. The warranty granted under clause 3 is limited to repair or replacement only.
® Registered Trade Mark of Spectrum Brands Inc., or one of its subsidiaries
7. Any parts of the Goods replaced during repairs or any product replaced remain the
© 2012 SBI
property of the manufacturer. In the event of the Goods being replaced during the
Rev. 05/12
Warranty Period, the warranty on the replacement Goods will expire on the same date
as for the Warranty Period on the original Goods which are replaced.
Part No. T22-0000154
11
LITHIUM-ION
STUBBLE TRIMMER
HT385-K091-01
2 YEAR WARRANTY
12
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
MB4040AU