Insert And Remove The Battery; Charge The Battery - Sharp PV300G Reference Manual

3. Select the Format Now button to format the card. This action will erase all
card contents.

Insert and Remove the Battery

To replace your rechargeable battery, or if you need to insert or remove
your SIM card, first you will need to remove the installed battery. Begin by
powering down your device:
1. Press and hold the power button for three seconds to power down.
2. Remove the back cover following the steps on page 6.
3. Push the battery in slightly (1) using protrusion at the lower right hand
corner of the battery then lift the battery (2) from that same edge to
remove it.
4. Insert the battery with the notched edge first (the edge with the gold
contacts) and then push the battery down to lock into place.
5. Replace the back cover.

Charge the Battery

Your device comes with a removable, rechargeable lithium-ion battery.
When you first receive your device, it is important that you fully charge the
battery as described below.
! Only use the charger and battery provided with your device or you risk
damaging your device.
! Do not insert battery chargers from into the stereo headset jack.
If you attach your device to your computer via USB, be aware that the
power received may not be enough to charge your device. For example,
when computers are in "sleep" mode, only a trickle charge may be supplied
via USB. In this situation you could lose more power than you gain. To
connect the device to your computer, insert the USB plug into your device's
USB port with the
1. Locate the battery charger that came in the box with your device. Insert
the charger's USB plug into your device's USB port, which is next to the
power button. Make sure the
icon on the top of the plug.
icon is on the top of the plug.
8