Printer - Radio Shack TRS-80 PC-4 Owner's Manual

• Data callou
t
Format:
GET ["filename"] variable 1 [, variable 2]
(Items in brackets may be omitted.j
This command can be used either manually or by writing it in a program.
For manual use, start the tape recorder in the PLAYBAC K position and operate as
follows.
GET ["filename"] variable 1 [, variable 2]
lED
For use in a program, write it in along a line number attached and start the program.
• Checking the file which has been recorded on the tape
A VER command is used to check whether the programs or data have been recorded
properly.
Format: VER
["filename"] (Item in brackets may be omitted.l
The operation sequence is similar to program load .
• Printer
An exclusive mini printer can be connected to the PC-4. By connecting this printer,
program lists, data and even calculation results during execution can be printed out.
For printer connection and operating procedures, refer to the Mini Printer Operation
Manual.
To print a program list, press
~
(2)
and designate the PRT mode.
Program list
iiJ~~(2J
LIST
GI
or
LIST A
1m
~leJ
(PRT mode release)
After printout is complete, be sure to press
~
(eJ
and release the PRT mode.
Also, to print calculation results or operation contents, printout can be performed
automatically by writina "MODE 7" and "MODE 8" in the program.
Example:
100 MODE 7
110PRINTA
120 MODE 8
When "MODE
7"
is written in the program, be sure to write "MODE 8" prior to
program termination and release the PRT mode.
-60-