Table of Contents
Advertisement
3. 3 BAND EO
+An equalizer with three frequency bands: BASS, MIDDLE, and TREBLE. The center frequencies for the middle and high bands are program·
mabie.
+ Parameters
A
BASS
[-7
~
7]
Gain (amplification degree} for the low band.
(BASS GAIN}
The center frequency for the middle band equalizer.
MID FREQ
The larger this value, the higher the center frequency.
8
(MIDDLE FREQUENCY}
[1
~
16]
1:250
2:350
3:450
4:550
5:650
6:700
7:750
8:800
9:850
10:900
11:950
12:1.00k
13:1.25k 14:1.5k
15:2.0k
16:2.5k
c
MID GAIN
[-7
~
7]
Gain for the middle band equalizer.
(MIDDLE GAIN}
The center frequency for the high band equalizer.
HIGH FREQ
The larger this value, the higher the center frequency.
D
( HIGH FREQUENCY}
[1
~
16]
1:850
2:900
3:950
4:1.00k
5:1.25k
6:1.5k
7:2.0k
8:2.5k
9:3.0k
10:3.5k
11:4.0k
12:4.5k
13:5.0k
14:5.5k
15:6.0k
16:6.5k
E
HIGH GAIN
[-7
~
7]
Gain for the high band equalizer.
F
TRIM
[0
~
15]
Gain for the input signal.
*Note
Use TRIM to prevent clipping.
If the gain for each frequency band is raised near its maximum, the output may be distorted (or clipped} even when the PEAK LED is not lit.
In such situations, turn down the TRIM parameter until the clipping stops.
4. PITCH•DELAY
+ PITCH•DELAY is an effect generated by combining a PITCH SHIFTER which changes the pitch of the input sound, and a DELAY, which
creates repeats of the input sound.
+There are two different modes: the PITCH+ DELAY Mode in which the PITCH SHIFTER and the DELAY are independent, and the SWEEP
DELAY Mode, in which the pitch becomes increasingly higher or lower as the DELAY effect repeats.
FEED BACK
MODE 1 -PITCH+ DELAY-
*Note
If you wish to have only the PITCH SHIFTER effect:
Select MODE 1 and set DELAY MIX at "0."
If you wish to have only the DELAY effect:
Select MODE 1 and set PITCH MIX at "0."
14
IN
-+-
MODE 2 -SWEEP DELAY-
OUT
Hide quick links:
Advertisement
Table of Contents
