Carburetor Adjustment; Engine Oil Replacement - Kohler PRO 2.0 iS Owner's Manual

1
2
33 590 03
6. Install the spark plug.
Spark plug tightening torque:
20 Nm (2.0 m·kgf, 14 ft·lbf)
TIP
If a torque wrench is not available when installing a
spark plug, a good estimate of the correct torque is
1/4–1/2 turn past finger tight. However, the spark plug
should be tightened to the specified torque as soon as
possible.
7. Install the spark plug cap and cap.
8. Install the cover and tighten the screws.
AE00431

Carburetor adjustment

The carburetor is a vital part of the engine. Adjusting
should be left to a Kohler portable dealer with the pro-
fessional knowledge, specialized data, and equipment
to do so properly.
AE00412

Engine oil replacement

WARNING
Avoid draining the engine oil immediately after
stopping the engine. The oil is hot and should be
handled with care to avoid burns.
1. Place the generator on a level surface and warm
up the engine for several minutes.
Then stop the engine and turn the fuel cock knob,
fuel tank cap air vent knob to OFF.
2. Remove the screws and then remove the cover.
1 Screw
7PB-030
2 Cover
KohlerPower.com 30