View Video Using Ip Address; Reset; Factory Default - Mitsubishi Electric NM-IP100 User Manual

NM‐IP100

6.2.2.View video using IP address

View the live video on a web page using your IP device and its IP address. To have the correct
IP address ready and use it on a web page:
1. Convert a MAC address to an IP address or check the IP address on the IPAdminTool.
(The MAC address is attached on the side or bottom of the device.)
MAC address = 00‐13‐23‐01‐14‐B1 → IP address = 192.168.20.177
the Hexadecimal number to Decimal number.
2. Open a web browser and enter the IP address of the device.
3. Click Continue to this website on the Security Certificate Alert page.
4. Click pop‐up blocked and install the ActiveX control. You need to install the ActiveX for
displaying the images.
5. Wait for a few seconds while the web page loads. The live video is displayed.

6.3. Reset

Hardware Reset is NOT supported. (Software Reset is available.)
To perform the Software Reset, please refer to the "HTTP API Manual" provided for your
encoder model.

6.4. Factory Default

Hardware Factory Reset is NOT supported. (Software Factory Reset is available.)
To perform the Software Factory Reset, please refer to the "HTTP API Manual" provided for
your encoder model.
14