Troubleshooting - Master-force 241-0854 Operator's Manual

PROBLEM
The tool will not start.
The motor is overheating. Too much pressure is
Page 17

TROUBLESHOOTING

CAUSE
The tool is not plugged
into a power source.
The circuit breaker is
tripped.
The cord is damaged.
being exerted on the tool.
Make sure the cooling
vents are free from dust
and obstacles.
SOLUTION
Plug the tool into a power source.
Reset the circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip, discontinue
use immediately and have the
tool serviced at an authorized
service center.
Have the cord or switch replaced
at an authorized service center.
Let the tool run under no load to
cool down.
Clean and clear the vents. Do not
cover vents with your hand during
operation.