Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Flat-blade and Phillips
screwdrivers
Scissors
Parts supplied
Check that all parts are included in parts package.
F
A
B
A. Window-lock bracket
³⁄₈
B. #8 x
" pan-head screws (6)
³⁄₄
C. #8 x
" round-head screws (5)
³⁄₈
D. #10 x
" pan-head screws (3)
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed.
Proper installation is your responsibility. Make sure you have
everything necessary for correct installation.
The location should provide:
Grounded electrical outlet within 4 ft (122 cm) of where the
power cord exits the air conditioner.
NOTE: Do not use an extension cord.
Free movement of air to rooms to be cooled.
A large enough opening for the air conditioner. Installation
parts are supplied for double-hung windows.
Adequate wall support for weight of air conditioner. Air
conditioner weighs 56 lbs (25 kg) to 80 lbs (36 kg).
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass freely through the cabinet louvers.
A
A. Cabinet louvers
INSTALLATION REQUIREMENTS
Tape measure
Drill and ³⁄₃₂" or smaller bit
G
H
E
D
C
E. Side curtains (2)
F. Top channel
G. Foam seal
H. Side curtain frames (2)
Window installation
Window opening measurements:
26" (66 cm) minimum to 38" (95.5 cm) maximum opening
width.
16" (40.6 cm) minimum opening height.
A. 26" (66 cm) minimum
B. 16" (40.6 cm) minimum
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
The electrical ratings for your air conditioner are listed on the
model and serial number label. The model and serial number
label is located on the right-hand side of the cabinet.
A
B
3