Check & Fill Engine Oil - Snapper LT-200 Series Operator's Manual

Check & Fill Engine Oil
Service Interval: Before each use, and every 8 hours.
1. Turn the engine off, and set the parking brake to
PARK.
2. Clean the area around the dip stick (C, Figure 22 or
23).
3. Remove the dip stick (C) and clean it with a paper
towel.
4. Insert the dip stick (C) back into the engine.
Briggs & Stratton Models, thread the cap back onto
the tube.
Kohler Models, push cap (C) firmly into place.
5. Remove the dip stick and read the oil level. The oil
level should be between the "FULL" and "ADD" marks
(D). If not, add oil according to the oil recommenda-
tions chart (Figure 25).
A
Figure 22. Briggs & Stratton Single Cylinder Models
A. Oil Drain Valve
B. Oil Filter
C. Dip Stick
D. Checking Oil Level
C
Figure 23. Briggs & Stratton Twin Cylinder Models
A. Oil Drain Valve
B. Oil Filter
C. Dip Stick
D. Checking Oil Level
25
Regular Maintenance
D
C
B
B
D
A