Advertisement
MOLEX CONNECTOR ASSEMBLY DIAGRAM
1. Carefully strip the outer insulation off of the bare end of the cigarette lighter plug cable and audio cable, back 1-1/2'.
Then strip the insulation off each individual wire back 1/4", unbraid 1-1/2" of the shield of the audio cable and twist into
a single conductor if the audio cable needs this step.
2. Place the stripped ends of both the dc and audio cables side by side and slide both the 1/4" and 3/8" shrink tubing
down over both until 2_3" of the cables protrude.
3. Follow the pictorial diagram for wire and jumper placement.
4. Twist the wire with the indicated jumper and crimp to the female socket. If you choose to solder, lay the twisted wire
jumper in the "U" portion of the female socket. Fold the both sets of "ears" down on your twisted wires using needle
nose pliers, then carefully solder only in the folded "ear" area.
5. Following the pictorial diagram, locate the correct hole location and insert the sockets into the rear (numbered end) of
the connector. A miniature screwdriver is helpful to push the sockets into the connector. The rear of the socket will
be recessed into it's hole about 1/16" when properly seated.
6. Slide the 1/4" shrink tubing up the cables, with the jumpers inside the tubing, until it is about 3/8" from the back of the
connector. Heat the shrink tubing uniformly until it shrinks down on the cables and jumpers. Now slide the 3/8" shrink
tubing up over the 1/4" tubing and heat until it shrinks down. Now slide the 3/4" shrink tubing over the connector,
allowing one half of the connector length to protrude from the tubing. Heat uniformly on all four sides of the connector
and down over the 3/8" tubing. Allow to cool.
7. Mount the speaker using the provided two page installation guide.
8. Plug the connectors together until they are fully seated.
9. You are now ready to plug !n the DC plug to 12VDC and the audio plug to your speaker output jack of your radio, and
enjoy great fidelity!!!
Motorola External (Amplified) Speaker
Models:
TLN2660A (Standard)
TLN2661B (VIP)
Note: This plug is as viewed from the numbered (back) side of the plug
Insert pins from the back side of the plug.
SSN2008A (VSP)
SSN2005B (VSP II)
Advertisement
