Whirlpool ET20NK Use & Care Manual page 4

Install properly... Remove sales labels.. .
Remove the Consumer Buy Guide label, tape
and any
inside
labels before using the re-
frigerator.
To remove any remaining glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
u
1.
Allow YZ inch (1.25 cm] space on each side and
at the top of the refrigerator for ease of
installation,
2. If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
Level refrigerator-freezer.. .
FRONT ROLLER
VELLING SCREW
IGHT TO RAISE;
LEFl TO LOWER
1. Remove base grille (see page 7).
2. To raise front, turn screw in the direction shown
3. To lower front, turn screw in the direction shown
4. Check with level.
5. Replace base grille (see page 7).
Clean it...
Clean your refriger-
ator before using it.
See cleaning instruc-
tions on page 8.
Plug it in...
J-PRONG
TYPE WALI
REFRIGERATOR
POWER CORD
J
I-PRONG
GROUNDIHG PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain.
See individual electrical requirements
and grounding instruction sheet in your literature
package.
4