Pmc-I/O Connector (P6204 And P7204); Transition Module - GE VR11 Reference Manual

Transition Module

GE Intelligent Platforms – VR11, VP11 Hardware Reference Manual, Second Edition
a
Weak 10kΩ pull-down (PDN) to GND and pull-up (PUP) to VIO.
NC Not connected
Reserved Reserved. Do not connect anything
V(I/O) I/O Voltage, connected with +5V
-12V Only available if connected at the CPCI backplane.

PMC-I/O Connector (P6204 and P7204)

Pin 1 of the I/O connector is PMCxIO_01. Pin 2 is PMCxIO_02 and so on. The
x denotes PMC1 or PMC2 respectively. All traces are not connected to any
onboard signal, and signal routing is neither paired nor length-matched to the
backplane connectors.
Important note:
In the partial PMC-IO configuration PMC2IO31 to PMC2IO60, PMC2IO63
and PMC2IO64 are not available. Make sure, that the PMC-IO pins don't
conflict with the IDE-signals!
Please refer to the appendix A for interface location and connector pin
assignments for the optional extension boards and transition modules.
Page 61