Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DIGITAL YACHT GPS150
Summary of Contents for DIGITAL YACHT GPS150
- Page 2 EGNOS in Europe the GPS150 will automatically switch to differential SBAS mode when available. The GPS150 will also be able to utilise, with a software update, the European funded Galileo positioning system when it comes on line (IOC – Initial Operation Capability) in 2018.
- Page 3 GPS or GLONASS satellite constellations or a combination of the two systems. Select the mode you want the GPS150 to operate in, connect it to a 12v or 24v DC supply and it will immediately start calculating your position and outputting this data in NMEA 0183 format (4,800, 38,400 or 115,200 baud).
- Page 4 The GPS150 should be connected to the boat’s DC supply via a 1 Amp fuse. The unit requires 9.6V to 28.8V supply voltage. The GPS150 has a number of operating modes that can be set by adjusting four DIP switches inside the unit. Section 4 of this manual explains how to select the different modes. By default the GPS150 will output;...
- Page 5 The GPS150 can be connected to a computer via a USB to NMEA adaptor. If you use the Digital Yacht NMEA to USB Adaptor, then the diagram below shows how to connect them together. The GPS150 can also be used wirelessly to send GPS data to an iPad/iPhone or Android device by using one of Digital Yacht’s WLN10 (4800 baud) or WLN10HS (38400 baud) Wireless NMEA Servers.
- Page 6 Power Up Sequence Failed* * NOTE – In some situations, where the switching of the power to the GPS150 is not cleanly made or it is made to quickly (not giving the internal voltages time to dissipate), the GPS150 Power Up Sequence may fail resulting in the selected operating mode not being setup correctly.
- Page 7 * These sentences output at 1HZ After changing the DIP switches, it is necessary to power cycle the GPS150 (turn off/on) before the new operating mode becomes active. Check the LED to make sure that the expected baud rate is active.
- Page 8 300g Protocols NMEA-0183 Version 3.01 NMEA messages GGA, GLL, RMC, VTG, GSA, GSV, ZDA Power Input VDC +9v to 34v Cable White 10m Shielded Cable (4.5mm OD) Quick Start Guide for GPS150 V1.02 TEL + 44 1179 554474 www.digitalyacht.co.uk sales@digitalyacht.co.uk...
Need help?
Do you have a question about the GPS150 and is the answer not in the manual?
Questions and answers