DIGITAL YACHT TriNav GPS160USB Installation And Instruction Manual

DIGITAL YACHT TriNav GPS160USB Installation And Instruction Manual

Positioning sensor

Advertisement

GPS160USB
POSITIONING
SENSOR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TriNav GPS160USB and is the answer not in the manual?

Questions and answers

Summary of Contents for DIGITAL YACHT TriNav GPS160USB

  • Page 1 GPS160USB POSITIONING SENSOR...
  • Page 2: Before You Start

    14 TPI thread mounting bracket for the GPS160USB. To coincide with the imminent “Full Operational Capability” (FOC) of the European Galileo system, Digital Yacht’s release of their TriNav™ GPS160USB smart positioning sensor will provide boat owners with a single sensor that will automatically read satellite data from the GPS, GLONASS and GALILEO constellations, choosing the best signals from over 80 satellites.
  • Page 3 GPS160USB to be flush mounted on a flat horizontal surface. A mounting kit (as shown in the diagram below) is available from Digital Yacht (Part# X500.400). In this situation, a bead of silicone sealant should be applied around the antenna, after mounting it, to avoid standing water accumulating under the antenna.
  • Page 4 The whole process takes about 2-3 minutes and is completely automatic. If you are on the boat with no internet connection, then insert the Digital Yacht Software and Drivers CD in to your PC and browse to the folder called “USB Drivers for AIS units”...
  • Page 5: Mode Selection

    To access the DIP switches, it is necessary to open the GPS160. It is recommended that this operation is only carried out by an approved Digital Yacht Dealer/Distributor, any physical damage to the PCB will not be covered by warranty.
  • Page 6 Operating Modes SWITCHES MODE SATELLITES BAUD RATE NMEA DATA Tri-Nav Legacy Mode (default) GPS+GLONASS+GALILEO 4800 1 HZ GGA/GLL/RMC/VLW/VTG/ZDA Tri-Nav 6Hz Mode GPS+GLONASS+GALILEO 4800 6 HZ RMC Tri-Nav All Satellite Info 4800 Baud GPS+GLONASS+GALILEO 4800 1 HZ GSA**/GSV**/RMC/ Tri-Nav All Sentences 1Hz GPS+GLONASS+GALILEO 38400 1 HZ DTM/GGA/GLL/GSA/GSV/RMC/VLW/VTG/ZDA...
  • Page 7: Technical Specification

    5. Technical Specification Receiver 72-channel U-Blox M8 engine GPS L1C/A, SBAS L1C/A, QZSS L1C/A, QZSS L1 SAIF, GLONASS L1OF, Galileo E1B/C Sensitivity -165 dBm typical Update Rate 1Hz by default (configurable up to 18Hz) Accuracy Position <1m with SBAS and 3.0-5.0m without SBAS typically (67%) Accuracy Velocity 0.05m/sec typically (50%) Time...

Table of Contents