Table of Contents
Advertisement
Opening the Housing
Lid Snaps have a Lock.
To open housing, push Lid Snap
Lock forward and lift as shown.
Keep pressure on the Lid Snap so
it does not fly open quickly.
Some lid snaps have a lot of
spring tension once they go over
center, so keep a firm grip on the lid snap.
Lid Snaps may be opened one at a time.
Installing the Camera
1. Remove any lanyard attached to the camera.
2. Pull out on each housing control until it stops. This will get the controls
out of the way for installation of the camera.
3. Remove the back from the housing.
4. The mounting tray for the camera is secured to the housing back.
Position the camera on the tray. Do not extend the camera flash.
5. Using a coin or screwdriver (preferred), secure the camera with the tray
mounting bolt which threads into the camera's tripod socket - Diagram A.
CAUTION:
Some camera tripod
socket threads are
plastic. The mounting
bolt is metal. Do not
cross thread or over
tighten as you may
damage the camera
tripod socket threads.
Push Forward
Lift
Tray Mounting Bolt
Diagram A
Lid Snap Lock
SONY
ZEISS
7
Advertisement
Table of Contents
