Fox Elite Bivvy Light Operating Instructions Manual

Fox Elite Bivvy Light Operating Instructions Manual

Halo elite bivvy light

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Elite Bivvy Light and is the answer not in the manual?

Questions and answers

Summary of Contents for Fox Elite Bivvy Light

  • Page 2 10 seconds to 30 minutes, before light switches off. • Can be used in conjunction with RX3 receiver and I-COM Interactive Transceiver, HALO ELITE BIVVY LIGHT or as a stand-alone unit, without a receiver. FEATURES: • Full remote control of all •...
  • Page 3 IMPORTANT NOTE: the new setting, i.e. 1 flash = level 1, 2 flashes Before using your Halo Elite for the first time, = level 2, …. etc …. 8 flashes = level 8. you must “register” it with your bite alarms Pressing the “sensitivity -“...
  • Page 4 “delay +” button. BATTERY REQUIREMENTS To decrease, press the “delay -“ button. The Halo Elite model requires 2 x 'C' size Each time a button is pressed, the light will (LR14) 1.5V alkaline batteries. flash briefly, to indicate the new setting, i.e.
  • Page 5 (supplied). With normal usage, this battery should have a very long life. Note: the Halo Elite has been designed for use in a bivvy. Please do not expose it to rain To fit/replace battery - insert a coin into or moisture.
  • Page 6 MAGNETIC MOUNTING SYSTEM DO YOU OWN AN RX3 RECEIVER OR To attach the Halo Elite to your bivvy - remove TXR+ SYSTEM? - if so, please go straight to the metal plate from the back. Hold the Halo “PROCEDURE(3) - Registration with an RX3 Elite up to the inside of your bivvy, in the receiver (including TXR+).”...
  • Page 7 1. Ensure the Halo Elite is switched OFF. 1. Ensure the Halo Elite and all your bite 2. Whilst HOLDING DOWN the “sensitivity +” alarms are switched OFF. button, switch the unit on. 2. Whilst HOLDING DOWN the “sensitivity +”...
  • Page 8 RX3, four times, so that all four (including TXR+) LEDs are flickering. 9. Switch on the Halo Elite. After a second This procedure should be followed if you own or so, the four LEDs on the RX3 should...
  • Page 9 7. Switch on the Halo Elite. After a second change alarms. or so, the I-COM will revert to its default • The Halo Elite will now respond to your bite editing screen and will emit a single beep. alarms, whether or not your RX3 receiver The light on the Halo Elite will also give a is in use.
  • Page 10 Halo is a registered trade mark. Halo ist ein eingetragenes Warenzeichen. Fox is a registered trade mark. FOX ist ein eingetragenes Warenzeichen. European registered designs. Eintragung des Musters für Europa. We reserve the right to alter or midify Wir behalten uns das Recht vor, Spezifikationen ohne specifications without prior notifications.

This manual is also suitable for:

Halo elite

Table of Contents