Advertisement
GETTING TO KNOW
YOUR PLANER
WARNING!: If any parts are missing, do
not operate your planer until missing parts
are replaced. Failure to do so could result
in serious personal injury.
Technical Specifications
Max. Planing Width ......................................................................3-1/4"
Max. Planing Depth ........................................................................1/32"
Max. Rabbeting Depth ..................................................................11/32"
Voltage ..........................................................................................120V
Amperage ........................................................................................4.4A
Cycle/Phase ....................................................................60Hz, 1 phase
Speed (ft./min.). ..........................................................................16,000
Getting to know your Planer
Soft Grip Housing
Dust Chute
Depth Adjustment Knob
Edge Guide Lock Knob
V Groove in
Aluminum Base
Edge Guide
Mounting hole
WARNING!: Do not use this product as a
component of others products. Also, do not
use attachments or accessories not recom-
mended for use with this product. Any such
use could result in possible serious injury.
Lock-on Button
Trigger
Belt Cover
Figure 1
ASSEMBLY & OPERATION
ADJUSTING DEPTH OF CUT
The depth of cut can be adjusted easily by
turning the Depth Adjustment Knob (A) Fig.2.
To increase the depth of cut, turn the knob
clockwise. To decrease the depth of cut, turn
the knob counterclockwise. Increments in mm
are shown on the top of the Depth Adjustment
Knob.
SWITCH & LOCK-ON BUTTON
To start the planer, pull the Trigger Switch (B)
Fig.2. Release the Trigger Switch to stop the
planer. This planer also comes with a
Lock-On Button (C) which allows continuous
operation without having to hold the Trigger
Switch. To engage this mechanism, pull the
Trigger Switch and press on the Lock-On
Button, the Trigger Switch will stay locked in
place until disengaged. Pull the Trigger Switch
to disengage the Lock-On mechanism.
ASSEMBLING AND USING EDGE GUIDE
Your planer comes with an Edge Guide (A)
Fig.3 which is used to guide the planer along
your workpiece. Place the planer on your
workpiece as shown in Fig.3 and then insert
the Edge Guide into its mounting hole (the
Edge Guide can be placed on either side of
the planer) until it comes in contact with the
side of your workpiece, then secure it by
tightening the Edge Guide Lock Knob (B).
Figure 2
Figure 3
Advertisement
