Adding Fuel; Wheel Kit Installation - Polaris Power P3000iE User Manual

FIRST USE INSTRUCTIONS

Adding Fuel

1. Remove the fuel tank cap (A).
2. Fill carefully to avoid spilling fuel on the fuel tank
strainer (B). Do not over ll the fuel tank (there
should be no fuel above the upper limit mark) .
3. Tighten fuel tank cap (A) securely until it clicks.
4. Position fuel valve lever OFF for storage or ON to
operate the generator.
ON
5. Move generator away from fueling source and site
before starting engine.

WHEEL KIT Installation

The unit comes with the rubber mounting feet installed. If
you wish to install the wheel kit, please perform the fol-
lowing procedure.
14
B
OFF
1. Axle assembly (1)
2. Locking swivel wheel (2)
3. Bolt M8X16 (4)
4. Wheel (2)
5. Bolt M6X16 (8)
Wheel assembly
First remove all four rubber mounting feet.
P ut a washer on each side of the wheel then slide them
on the axle securing with a lock pin.
1. Wheel (2)
2. Axle (1)
3. Lock pin (2)
4. Washer (4)
Locking swivel wheel.
Secure each locking swivel wheel with 4 M6X16 bolts.
1. Locking swivel wheel
2. Bolt M6X16