Makita DLM380 Instruction Manual page 6

Overdischarge protection
1
014503
When the remaining battery capacity gets low, the
battery indicator blinks on the applicable battery side.
By further use, the tool stops and the battery indicator
lights up about 10 seconds. In this situation, charge the
battery cartridge.
Power switch action
WARNING:
Before installing the battery cartridge in the
•
tool, always check to see that the switch lever
actuates properly and returns to the original
position when released. Operating a tool with a
switch that does not actuate properly can lead to
loss of control and serious personal injury.
NOTE:
Trying to mow much grass at a time may not allow
•
the motor to start due to the overload. At this time,
change the mowing height to higher level to restart.
The mower does not start without pressing the
•
switch button even if the switch lever is pulled.
This mower is equipped with the interlock switch and
handle switch. If you notice anything unusual with either
of these switches, stop operation immediately and have
them checked by your nearest Makita Authorized or
Factory Service Center.
1. Install the battery cartridges. Insert the lock key
into the interlock switch and then close the
battery cover.
1
014485
2. Press the switch button.
3. Pull the switch lever toward you while pressing
the switch button.
1. Battery indicator
1. Battery cartridge
2
2. Lock key
2
1
014488
4. Release the switch button as soon as the motor
starts running. The mower will continue to run
until you release the switch lever.
5. Release the switch lever to stop the motor.
6. When not in use, remove the lock key. Store the
lock key in a safe place out of reach of children.
Adjusting the mowing height
WARNING:
Never put your hand or leg under the mower unit
•
when adjusting the mowing height.
Always make sure that the lever fits in the groove
•
properly before operation.
2
B
014486
The mowing height can be adjusted in the range of
between 25 mm - 75 mm (1.0" - 3.0").
1. Remove the lock key.
2. Pull the mowing height adjusting lever toward A
side. Move it to your desired mowing height level.
Make sure that the pins on the mowing height
adjusting lever fit in the holes and the lever returns
to B side.
NOTE:
The mowing height figures should be used just as
•
a guideline, as the state of the lawn or ground may
cause lawn height to be slightly different to the set
height figure.
Try a test mowing of grass in a less conspicuous
•
place to get your desired height.
It is easier to move the mowing height adjusting
•
lever with holding the tool firmly.
6
1. Switch button
2. Switch lever
1. Mowing height
adjusting lever
2. Pins
A
1