JVC Blank Media LYT1015 Instructions Manual page 11

CAPTURING VIDEO (cont.)
5
Click the USB input (USB) button.
The USB input mode screen appears.
6
Click the Video button.
The amount of available storage space is
displayed in the information display panel.
7
Click the Capture button.
The capture operation begins, and the message
[Capture in progress] appears.
8
Click the Capture button again.
The capture operation ends, and the message
[Converting to MPEG] appears. Once
conversion ends, the video file (extension
".mpg") is registered in the album.
NOTE:
If you are using Windows
files cannot be converted to MPEG4 files with
ImageMixer, install Windows Media™ Player
(version 7 or later). Windows Media™ Player can
be loaded from Microsoft's web site:
http://www.microsoft.com/
Capturing still images
1
Click the Still image button.
The message [Still image capture enabled]
appears on the information display panel.
2
Click the Capture button.
The video image at the moment that the button
was clicked is captured, and the resulting still
image file (extension ".jpg") is registered in the
album.
Camcorder operations are limited to the
zoom switch, the focus button, and the still
image button.
NOTES:
It is not possible to capture videos or still images
if the USB Mass Storage Class driver is not
installed properly. In this case, refer to "Updating
[Device Manager] (Windows
Software Installation and USB Connection
Guide.
On the information display panel or the file
information dialog, some information such as
file-created date may be incorrect.
Disconnecting the USB cable
1
Disconnect the USB cable.
2
Set the Power Switch on the camcorder to "OFF".
The camcorder turns off.
®
2000 and the MPEG1
®
)" ( pg. 8) in the
Information display panel
Still image Information display panel
11
EN
USB input (USB)
Capture
Video
Capture