Raymarine Remote display Quick Start Manual page 6

Quick start guide for Remote Display
To select a different display for control
Repeatedly press the
highlighted. The screen of the newly selected display will flash to indicate
that it is under remote control.
To control the selected display.
Pressing the
same effect as pressing that same button on the controlled display. For
example, pressing the
to the next chapter.
The full range of operation and configuration functions on the controlled
display is available by pressing keys on the Remote Display.
Note: The first press of
the screen of the controlled display to stop flashing but the controlled
display remains under remote control until the Remote Display exits remote
control mode.
To exit Remote Control mode
Press and hold the
information display mode.
If a period of thirty seconds elapses without a key press, remote control
mode is automatically cancelled and the Remote Display returns to
information display mode.
Keylock
Keylock can be enabled or disabled in setup to protect from accidental key
presses
When keylock is enabled, pressing a key causes the unit to give the unlock
key prompt. Press
keys to function for one minute, after which the keys will automatically
relock).
Alarms
A number of data alarms can be configured in setup. See page 5
4
, , or
button will cause the controlled display to scroll
, ,
button. The Remote Display returns to
followed by
button until the required display is
button on the Remote Display has the
or on the remote display causes
to unlock the keys (this will allow the
www.raymarine.com