Menu Guide; Installation - Open Sky DigiTECH 5000F User Manual

5

. MENU GUIDE

The main menu is classified into five menus which will carry out the various
operation individually.
Main Menu
Press "OK" key to move to Channel Search menu after storing your selection in Antenna
Setup.
a. Satellite : You can select the desired satellite using the volume "UP/DOWN" (◀∙▶)
keys.
b. LNB Power : You can select the LNB Power ON or OFF. Using the volume
"UP/DOWN" (◀∙▶) keys.
c. LNB Type : You can select the Universal LNB or Standard LNB. Using the volume
"UP/DOWN" (◀∙▶)keys.
10
Press the "MENU" key in the RCU. You will see
the "Main Menu" on the screen.
1) You can move into the desired submenu using
"UP" key or "DOWN" key.
2) Press "OK" key to confirm your selection.
3) Press the "MENU" key or "EXIT" key to return
to previous menu.

5.1. Installation

This is to install Antenna Setup, Channel Search,
Factory Default and Code.
5.1.1 Antenna Setup
In this menu you can see satellite information and
antenna (dish) setup.
Select theSatellite, LNB Power, LNB Type, LNB
High, LNB Low, 22KHz, DiSEqC Type or DiSEqC
1.2 motor.
d. LNB High : You can select the LNB Frequency. Using the volume "UP/DOWN"(◀∙▶)
keys or numeric keys.
e. LNB Low : If you can use the Universal LNB, you can select the LNB low frequency.
Using the volume "UP/DOWN" (◀∙▶)keys or numeric keys.
f. 22KHz : If you have 22KHz tone box, you can supply either 22KHz by setting "ON" or
not by setting "OFF". Using the volume "UP/DOWN" (◀∙▶)keys or numeric keys.
g. DiSEqC Type : If you have DiSEqC box, you can select and use appropriate port for
your DiSEqC box. Using the volume "UP/DOWN"(◀∙▶) keys.
h . DiSEqC 1.2 motor : If you have DiSEqC 1.2 motor, please select " On.
5.1.2 Channel Search
d. Delete Satellite : You can delete USER satellite using the "OK" key.
e. Add TP : You can add a new transponder using the "OK" key.
f. Delete TP : You can delete transponder using the "OK" key.
g. Search mode : You can select the FTA(free to air)+SCM(scrambled) or FTA, SCM
using the volume 'UP/DOWN"(◀∙▶) keys.
h. Transponder Search : Press "OK" key to start transponder search for selected
transponder.
i. Satellite Search : Press "OK" key to start satellite search for selected satellite.
The menu shows all transponders in satellite and
edit satellite, edit transponder to scan the
satellite.
a. Satellite : You can select the desired satellite
using the volume "UP/DOWN"(◀∙▶) keys. If you
want Multi Search, press "OK" key and then
select other satellites.
b. Network : You can select the Network search
using the volume "UP/DOWN"(◀∙▶) keys.
c. Add Satellite : You can add a new satellite
using the "OK" key.
11