Advertisement
Flexible LED light
The Solar ReStore is equipped with a side-loaded, (5) Flexible LED light. It pro-
vides 20 hours of continuous light on a single charge. It can be used as a reading
light, emergency backup light, for camping and more. Simply slide the (3) Control
switch the LED position to turn on the light. Slide the (3) Control switch to the
OFF position when you are finished so that you do not drain the Solar ReStore's
battery power.
Troubleshooting
When I connect my device to the Solar ReStore, it does not begin charging.
- Make sure that you have charged the Solar ReStore's internal backup battery by
either solar, USB, or AC charging. Press the (8) CHECK button on the (6) Capacity
indicator to see how much battery power is left.
- Check to see that the (3) Control switch is in the ON position and that the (4)
Status LED is glowing BLUE.
- Please ensure that both ends of the USB cable you are using are securely and
fully connected.
The Solar ReStore is not charging my device by solar power.
- The Solar ReStore is not designed as an ACTIVE solar charger. You must first
place the Solar ReStore in direct sunlight for 1-6 hours, and please be sure that
the (3) Control switch is in the OFF position. After it has charged in direct
sunlight, you should then connect your device to the Solar Restore for a bat-
tery boost. Please note, 6 hours of direct sunlight is required to charge the Solar
ReStore to 50% capacity. You will see the (4) Status LED glow RED to indicate
solar charging.
- Please make sure that the (5) Flexible LED light is not on.
Advertisement
