Table of Contents
Advertisement
Setting and operating
elements
Legend
6
Set of DIP switches
DIP switch no.
Meaning
1
Fan control
2
Operating mode change-
over via external switch
2)
3
Operating action of switch
for external operating
mode changeover
2)
4
Standby
2)
5
Switching differential
1)
Factory setting
2)
Only with the RCC10
Accessories
5
2
3
5
6
4
1
1. Operating mode selector
(standby
, heating or cooling mode with manual selection of fan speed)
2
LEDs for indicating heating mode, cooling mode and fan operation
3
Setting facility for minimum setpoint limitation
(in increments of 1 K)
4
Setting facility for maximum setpoint limitation
(in increments of 1 K)
5
Room temperature setpoint knob
Position ON
Fan control is temperature-
dependent in all operating
modes
Changeover between normal
operation and energy saving
mode
Changeover activated when
contact of switch is closed
1)
(N.O.)
Frost protection function not
enabled
1 K in heating mode
0.5 K in cooling mode
The RCC10.1 comes with the following fixed settings:
•
Switching differential in heating mode:
•
Switching differential in cooling mode:
•
Standby:
•
Operating action of switch for external
operating mode changeover:
Adapter plate 120 x 120 mm for 4" x 4" conduit boxes
Adapter plate 96 x 120 mm for 2" x 4" conduit boxes
Adapter plate for surface wiring 112x130 mm
Position OFF
Fan control in normal operation (and in
energy saving mode with the RCC10.1) is
temperature independent
Changeover between normal operation
and standby
Changeover activated when contact of
switch is open
(N.C.)
Frost protection function enabled
1)
4 K in heating mode
1)
2 K in cooling mode
2 K
1 K
OFF, no frost protection
N.O.
Description
1)
1)
1)
Type reference
ARG70
ARG70.1
ARG70.2
Advertisement
Table of Contents
