Connecting The Solaredge Gateway; Device Discovery - SolarEdge Home Gateway Installation Manual

Chapter 3: Installing the SolarEdge Home Gateway

Connecting the SolarEdge Gateway

1
Install the supplied ZigBee slave module in the slave device
(inverters or SMI) as described in the ZigBee Slave Kit
Installation Guide. To connect more slaves, purchase an
additional ZigBee slave kit for each slave device (sold
separately).
2
Connect the power supply to the USB connector and connect
to an AC source. The power LED is lit to indicate power
connection.
3
Connect the Ethernet cable between the gateway connector
and the router or switch used to connect to the Internet.

Device Discovery

Press the configuration button on the home gateway for 5-10
seconds and release. Release the button after all LEDS have turned
on. The gateway starts discovering the slave device(s). The device
discovery may take 2-3 minutes, during which all the LEDs blink. The
signal strength LEDs also light up (refer to LEDs on page 13).
16
Home Gateway Installation Guide – MAN-01-00118-1.4